Elsema G-2025 Programming Instructions and What it is used for

Elsema G-2025 Programming Instructions and What it is used for

ELSEMA G-2025 is a remote control transmitter commonly used to operate gate and garage door operator roller shutters and other devices that can be remotely controlled.

To use G-2025:

You must have a compatible receiver that can receive the signal from the transmitter and activate the device you want to control.

If you already have a compatible receiver installed.

Only then can you use the G-2025 transmitter to control your device by following these steps.

Locate the buttons on the G-2025 transmitter that you want to use to control your device.

The G-2025 can be programmed to transmit up to four different signals so put your receiver in programming mode to select the button(s) that correspond to the function(s) you want to control.

The procedure will vary depending on the receiver you are using, so consult the instructions that came with your receiver for details.

Press and hold the button on the G-2025 transmitter you want to program, and then release it when the transmitter's LED starts to flash.

Within a few seconds, press the button on the receiver that you want to connect to the G-2025 transmitter button.

The transmitter's LED should stop flashing, indicating that programming was successful.

Repeat this process for each button on the G-2025 transmitter you wish to program.

Once you have programmed your G-2025 transmitter.

You will be able to use it to control your device by pressing the appropriate button.

If you encounter any problems or have additional questions, refer to the user manual for your device or contact the manufacturer for assistance.
If you do not already have a compatible receiver installed, you will need to purchase one separately and install it according to the manufacturer's instructions.

The receiver should be compatible with the G-2025 transmitter and the device you want to control.

It is important to note that the G-2025 transmitter operates on a fixed frequency (433.92 MHz) and uses a rolling code encryption to prevent unauthorized access.

This means that the receiver you choose will also operate on the same frequency and be compatible with the rolling code encryption used by the G-2025 transmitter.

Additionally you should make sure that the device you want to control is compatible with the G-2025 transmitter and the receiver you choose.

Some devices may require certain types of receivers or may not be compatible with certain types of transmitters.

Overall, the ELSEMA G-2025 transmitter is a useful device for remotely controlling gate and garage door operators, roller shutters and other devices.

Follow the steps above and make sure you have a compatible receiver and device.

You can easily use the G-2025 to control your devices remotely.