How to Setup NVR 64 Port Channel Details

How to setup NVR 64 port channel Details

To setup Cctv NVR (Network Video Recorder) you have a 64 port channel NVR which is used to specify the collection of security cameras and the number of people.  You can setup your NVR by following the steps below.

Step 1: Confirm Channel Connection:
First make sure your NVR can use the proper port for channel connection.  It will be important to know about your nearest internet router where you can change the NVR channel ports.

Step 2: Connect the camera:
Here you need to connect each camera with one port of your NVR.  Can use one network cable for each camera.

Each camera can be connected to a network switch through one port and then connected to a port on the NVR through this Poe switch.

Step 3: Setup the NVR configuration:
Access your NVR's user interface.  Next, go to the network settings or configuration menu located regularly on the screen.

Step 4: Configure Camera Settings:
The network settings menu will now redirect you to the cameras network settings.  Here, provide the correct network parameters (such as IP address, subnet mask, gateway and port number) for each camera.

Step 5: Configure Storage:
The next step in NVR setup is storage configuration.  In this step you need to determine the NVR's storage parameters (such as storage capacity, storage loop cycling, storage format).  You go to the Storage Configuration menu and select the desired settings.

Step 6: Change network settings:
After the storage configuration is completed, go back to the network settings menu and set the correct protocol and port for the connection between the NVR and the Internet router.  Usually, it is TCP/IP protocol and default port can be 80 or 8000.

Step 7: Test the connection:
After configuring everything, you can test the connection through the network and through your Internet router to be sure.

And you open a web browser using the NVR's IP address and go to the NVR's login page.  You were able to login correctly and display the camera, but the connection was established correctly.

Step 8: Resonance and Configuration Changes:
After testing the connection, you can change the camera settings and NVR configuration as needed.  You can set various features for cameras and NVRs, such as motion detection, recording time, archive settings, and change network settings.