Process RJ45 Connector Cable Clipping

Process RJ45 Connector Cable Clipping 

First RJ45-Clipping an Internet Cat6 RJ45 cable is the process of cutting the wire to the desired length and attaching an RJ45 connector to its end. Here are the steps to do this:
Measure the required cable length: Use a measuring tape to determine the cable length required for your specific application. Be sure to add a few extra inches to make sure you have enough slack to work with.

Wire cutting: Use a sharp pair of wire cutters to cut the wire to the desired length,

Strip the wire: Use a wire stripping tool to remove about an inch of outer jacket from the end of the wire. This will reveal eight wires inside.

Cables Open and sort the wire pairs: Open the wire pairs and sort from left to right in the following order:

White/Orange, Orange, White/Green, Blue, White/Blue, Green, White/Brown, Brown. 

Be sure to twist each pair of wires together as you arrange them.

Trim the wires: Use a wire cutter to trim the ends of the wires so they are the same length, Insert the cables into the RJ45 connector: Insert the cables into the RJ45 connector in the correct order. 

Make sure each goes into its appropriate slot and is fully inserted, Crimp the connector: Use a crimping tool to crimp the connector to the cable. Make sure the connector is fully seated and the cables are securely held in place.

Check the cable: Once the connector is connected, use a cable tester to check the continuity of the cable and make sure it is wired correctly.

Following these steps should result in a properly clipped Cat6 RJ45 cable that can be used for a variety of networking applications, Follow picture color number. 

✅

1> White_Orange ✅

2> Orange ✅
3> White_Green ✅
4> Blue ✅
5> White_Blue ✅
6> Green✅
7> White_Browne ✅
8> Browne ✅

Checking-in Serial cable clipping number.

Read more post link:

CCTV Camera Installed Technician

Hidden Wireless  Camera Details

Installing a CCTV Camera Outside the House

Solar Powered Security Camera With WiFi